Providing you the best range of delta vfd007s21a vfd-s series drive, schneider electric atv12h075m2 ac driver, ac drives single phase schneider and ac drives three phase schneider with effective & timely delivery.
₹ 8000 / Piece Get Latest Price
| Brand | Delta |
| Model Name/Number | VFD007S21A |
| Input Phase | 1 - Phase |
| Enclosure Rating | IP20 |
| Series | VFD-S |
| Nominal Input VAC | 240 Volts AC |
| Input Range VAC | 200 to 240 Volts AC |
| HP (CT) | 1 Horsepower |
| Amps (CT) | 1 Amps |
| Operator Controls | Built In |
| Max. Frequency | 400 Hertz |
| Braking Type | DC Injection Dynamic Braking |
| Max. Applicable Motor Output (kW) | 0.2 |
| Max. Applicable Motor Output (HP) | 0.25 |
| Weight (kg) | 1.3 kg |
Minimum order quantity: 2 Piece
General Purpose AC Micro Drive. Delta Electronics’ most cost effective general purpose drive. The VFD-S series drive is famous for its low-noise carrier frequency feature and easy to use keypad. Applications: Air conditioner for large buildings; water supply system for large buildings; temperature control of middle/large oven; webbing loom; packing machine; conveyor belt; fan of drying machine, etc.
₹ 14500 / Piece Get Latest Price
| Brand | Schneider |
| Model Name/Number | ATV12H075M2 |
| Network Number Of Phases | Single Phase |
| Rated Supply Voltage | 240 V |
| Motor Power Kw | 0.75 kW |
| Motor Power HP | 1 hp |
| Communication Port Protocol | Modbus |
| Line Current | 10.2 A |
| Speed Range | 1-20 RPM |
| Transient Over torque | 150-170 % of nominal motor torque depending on drive rating and type of motor |
| Ip Degree Of Protection | IP20 without blanking plate on upper part |
Minimum order quantity: 10 Piece
| supply frequency | 50/60 Hz +/- 5 % |
|---|---|
| connector type | 1 RJ45 (on front face) for Modbus |
| physical interface | 2-wire RS 485 for Modbus |
| transmission frame | RTU for Modbus |
| transmission rate | 4800 bit/s 9600 bit/s 19200 bit/s 38400 bit/s |
| number of addresses | 1…247 for Modbus |
| communication service | Read holding registers (03) 29 words Write single register (06) 29 words Write multiple registers (16) 27 words Read/write multiple registers (23) 4/4 words Read device identification (43) |
| prospective line Isc | 1 kA |
| continuous output current | 4.2 A at 4 kHz |
| maximum transient current | 6.3 A for 60 s |
| speed drive output frequency | 0.5…400 Hz |
| nominal switching frequency | 4 kHz |
| switching frequency | 2...16 kHz adjustable 4...16 kHz with derating factor |
| braking torque | Up to 70 % of nominal motor torque without braking resistor |
| motor slip compensation | Preset in factory Adjustable |
| output voltage | 200...240 V 3 phases |
| electrical connection | Terminal, clamping capacity: 3.5 mm², AWG 12 (L1, L2, L3, U, V, W, PA, PC) |
| tightening torque | 0.8 N.m |
| insulation | Electrical between power and control |
| supply | Internal supply for reference potentiometer: 5 V DC (4.75…5.25 V), <10 mA, protection type: overload and short-circuit protection Internal supply for logic inputs: 24 V DC (20.4…28.8 V), <100 mA, protection type: overload and short-circuit protection |
| analogue input number | 1 |
| analogue input type | Configurable current AI1 0...20 mA 250 Ohm Configurable voltage AI1 0...10 V 30 kOhm Configurable voltage AI1 0...5 V 30 kOhm |
| discrete input number | 4 |
| discrete input type | Programmable LI1...LI4 24 V 18...30 V |
| discrete input logic | Negative logic (sink), > 16 V (state 0), < 10 V (state 1), input impedance 3.5 kOhm Positive logic (source), 0...< 5 V (state 0), > 11 V (state 1) |
| sampling duration | 20 ms, tolerance +/- 1 ms for logic input 10 ms for analogue input |
| linearity error | +/- 0.3 % of maximum value for analogue input |
| analogue output number | 1 |
| analogue output type | AO1 software-configurable voltage: 0...10 V, impedance: 470 Ohm, resolution 8 bits AO1 software-configurable current: 0...20 mA, impedance: 800 Ohm, resolution 8 bits |
| discrete output number | 2 |
| discrete output type | Logic output LO+, LO- Protected relay output R1A, R1B, R1C 1 C/O |
| minimum switching current | 5 mA at 24 V DC for logic relay |
| maximum switching current | 2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms logic relay 2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms logic relay 3 A 250 V AC resistive cos phi = 1 L/R = 0 ms logic relay 4 A 30 V DC resistive cos phi = 1 L/R = 0 ms logic relay |
₹ 11110 / Piece Get Latest Price
| Brand | Schneider |
| Input Phase | 1 - Phase |
| Display Type | Digital |
| Body Material | Plastic |
| Voltage | 240 V |
| Frequency | 50/60 Hz |
₹ 11110 / Piece Get Latest Price
| Brand | Schneider |
| Input Phase | 3 - Phase |
| Voltage | 380 V |
| Frequency | 50/60 Hz |
| Display Type | Digital |
| Color | Black |
| Usage/Application | Industrial |
Anuj Gupta (Electrical Engineer)
Perfect Electric Co
1992, Ground Floor, Katra Lachhu Singh, Bhaghirath Palace
Chandni Chowk, New Delhi - 110006, Delhi, India